Xlt XD-9007A (ELEC Oven Version – C, AVI Hood Version Manuel d'utilisateur télécharger pdf (Page 20)

Technical Support US: 888-443-2751 Technical Support INTL: 316-943-2751

HOOD SERVICE PROCEDURES

Complete VFD manual available at www.xltovens.com.

Hitachi X200 Restoring AVI Defaults

Access program parameters by pressing the <FUNC> button one time and using the up and down

arrow buttons to navigate to the appropriate parameter press the <FUNC> button again to make

adjustments to that parameter by using the up and down arrows. To store the new settings press the

<STR> button one time.

B031 = 01

B084 = 01

Press and hold the <FUNC> <Down Arrow> and <Stop/Reset> buttons all at the same

time. Release the buttons all at once and the country code should appear in the dis-

play (USA). Hitachi’s factory settings are now restored.

To install AVI Defaults press <FUNC> button one time and enter following parameters

A001 = 01

A003 – USA = 60 Hz. World = 50 Hz.

A082 = Supply voltage at location 200, 215, or

230 choose appropriate voltage.

A093 = 3000

A094 = 01

A096 = 10

B002 = 25

C001 = 02

C002 = 03

C003 = 04

C004 = 05

C014 = 00

F001 = See Figure 1

H004 = 4

B031 = 03

Put controller into display mode by pressing the <FUNC> button and holding until d001 appears

on the display release and then press the <FUNC> button one time. The display should show

0.0.

Test run the motor by turning on one of the oven/hood switches located on the face of the hood.

Read the entire instruction before programming.

TIP

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 63 64

Pas de commentaire

Xlt XD-9007A (ELEC Oven Version – C, AVI Hood Version Manuel d'utilisateur Page 20