Xlt XD-9007A (ELEC Oven Version – B1, AVI Hood Version Manuel d'utilisateur télécharger pdf (Page 20)

Technical Support US: 888-443-2751 Technical Support INTL: 316-943-2751

HOOD SERVICE PROCEDURES

Complete VFD manual available at www.xltovens.com

Hitachi X200 Restoring Factory Defaults

Access program parameters by pressing the <FUNC> key one time and using the up and down ar-

row keys to navigate to the appropriate parameter press the <FUNC> key again to make adjust-

ments to that parameter by using the up and down arrows. To store the new settings press the

<STR> button one time.

B031 = 01

B084 = 01

After pressing the <STR> key Press and hold the <FUNC> down arrow key and <Stop/

Reset> key all at the same time. Release the keys all at once and the country code

should appear in the display (USA). Hitachi’s factory settings are now restored.

A001 = 01

A003 – USA = 60 Hz. World = 50 Hz.

A082 = Supply voltage at location 200, 215, or 230 choose appropriate voltage.

A093 = 3000

A094 = 01

A096 = 10

B002 = 25

C001 = 02

C002 = 03

C003 = 04

C004 = 05

C014 = 00

F001 = See Figure 1

H004 = 4

B031 = 03

Put controller into monitor mode by pressing the <FUNC> and holding until d001 appears on the

display release and then press the <FUNC> one time. The display should show 0.0.

Put the controller in Run mode by pressing the <RUN> key one time. The Run indicator light lo-

cated next to the speed control knob should illuminate.

Test run the motor by turning on one of the oven/hood switches located on the face of the hood.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 55 56

Pas de commentaire

Xlt XD-9007A (ELEC Oven Version – B1, AVI Hood Version Manuel d'utilisateur Page 20