Xlt XD-9004B Manuel d'utilisateur télécharger pdf (Page 20)

Technical Support US: 888-443-2751 Technical Support INTL: 316-943-2751

OVEN ASSEMBLY

XLT ovens can easily be moved and stacked with the proper lifting equipment. The use of

XLT approved lifting equipment is highly recommended. Contact XLT for more information.

WARNING & SAFETY INFORMATION

 These ovens are heavy & can tip or fall causing bodily injury.

 NEVER place any part of your body beneath any oven that is suspended by the

lifting jacks. A crush hazard exists if the oven falls or slips.

 DO NOT place your hands on the lifting jack vertical pole beneath the jack’s

winch. As the jack’s winch descends when you turn the jack handle, a pinch

point is created between the winch & the pole.

WARNING

BE CAREFUL when rolling the oven on the cart, especially when going up or

down ramps & over bumps. Leave the straps/banding on until the oven is near

the assembly area.

CAUTION

 Make sure that the notch on tube of the winch assembly is aligned with the pin

in the tripod base as shown. These alignments are important and keep the jack

aligned properly.

 Check for smooth operation. The cable should not be pinched and should pass

smoothly over the pulley on top of the pole assembly.

 Inspect cable prior to each use.

 If cable is frayed or shows signs of excessive wear and tear, DO NOT USE until

cable is replaced.

 At a minimum replace the cable annually with wire rope that meets or exceeds

the jack manufacturer’s specifications.

 Do not exceed the stated capacity of the jack.

WARNING

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 105 106

Pas de commentaire

Xlt XD-9004B Manuel d'utilisateur Page 20